TFS1200 Datasheet PDF - Vectron International


www.Datasheet-PDF.com

TFS1200
Vectron International

Part Number TFS1200
Description VI TELEFILTER
Page 5 Pages

TFS1200 datasheet pdf
View PDF for PC
TFS1200 pdf
View PDF for Mobile


No Preview Available !

Filename: tfs 1200.doc
VI TELEFILTER
Version 1.3
Filter specification
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
23 °C
0 dBm
168// -1,0pF
168// -1,0pF
TFS 1200
09.06.2006
1/5
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 1200 is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 1200,0 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
Insertion loss
(reference level)
ae
Nominal frequency
fN
Centre frequency
fC
Passband
PB
Pass band ripple
p-p
Relative attenuation
fN
… fN ±
0,1
fN ±
fN ±
fN +
fN +
fN -
3
6
17
30
17
MHz … fN ±
6
MHz … fN ± 17
MHz … fN + 30
MHz … fN + 180
MHz … fN - 1150
Group delay ripple within PB
arel
MHz
MHz
MHz
MHz
MHz
MHz
Input power level
Operating temperature range
OTR
Storage temperature range
Frequency inversion temperature
Temperature coefficient of frequency
TCf **
typ. value
3,25 dB
-
1200,0
-
0,3
MHz
dB
0,3
20
28
33
43
39
19
26
-
-
40
0,05
dB
dB
dB
dB
dB
dB
ns
dBm
°C
ppm/K2
tolerance / limit
max.
6,0 dB
fN
max.
1200,0
-
± 100,0
1,0
MHz
kHz
dB
max.
1 dB
min. 15 dB
min. 20 dB
min. 25 dB
min. 30 dB
min. 30 dB
max. 100 ns
max.
15 dBm
- 40 °C ... + 85°C
- 45 °C ... + 90°C
-
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) f(Hz) = TCf(ppm/K2) x (T-T0)2 x fTo(MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
www.DataSheet4U.net



No Preview Available !

Filename: tfs 1200.doc
VI TELEFILTER
Version 1.3
Filter specification
TFS 1200
09.06.2006
2/5
Filter characteristic
0
0
0.5
-10
-2 0.45
-20
-4 0.4
-30
-6 0.35
-40
-8 0.3
-50
-60 -10 0.25
1065 1092 1119 1146 1173 1200 1227 1254 1281 1308 1335
1199 1199.5 1200 1200.5 1201 1201.5
frequency in MHz
frequency in MHz
Construction and pin connection
(All dimensions in mm)
C00
U23
1 Ground
2 Input
3 Ground
4 Ground
5 Ground
6 Output
7 Ground
8 Ground
50 Ohm Test circuit
Date code:
U
V
W
...
Year + week
2006
2007
2008
26
1, 3, 4, 5, 7, 8
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information



No Preview Available !

Filename: tfs 1200.doc
VI TELEFILTER
Version 1.3
Filter specification
TFS 1200
09.06.2006
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Tape (all dimensions in mm)
W : 12,00 ± 0,3
Po : 4,00 ± 0,1
Do : 1,50 +0,1/-0
E : 1,75 ± 0,1
F : 5,50 ± 0,05
G(min) : 0,75
P2 : 2,00 ± 0,05
P1 : 8,00 ± 0,1
D1(min) : 1,50
Ao : 4,30 ± 0,1
Bo : 4,30 ± 0,1
Ct : 9,5 ± 0,1
Reel (all dimensions in mm)
A :330
W1 : 12,4 +2/-0
W2(max) : 18,4
N(min) : 50
C : 13,0 +0,5/-0,2
t
Ko
A
Pull Off Direction
P1
Do
Date Code
Po
P2
Typ PIN Marker
D1
W2
Ao
C
N
The minimum bending radius is 45 mm.
W1
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information



No Preview Available !

Filename: tfs 1200.doc
VI TELEFILTER
Air reflow temperature conditions
Version 1.3
Filter specification
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
TFS 1200
09.06.2006
4/5
Temperature / °C
Chip-mount air reflow profile
max. 260°C
217°C
max. 300 s
10 ... 30 s
30 ... 150 s
Time / s
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information




TFS1200 datasheet pdf
Download PDF
TFS1200 pdf
View PDF for Mobile


Similiar Datasheets : TFS120 TFS1200 TFS120A TFS120C TFS120E TFS121 TFS121B TFS1220 TFS1220B TFS1237 TFS124 TFS125A TFS125B TFS125C TFS125D TFS125G TFS125H TFS125K TFS125L

Index :   0   1   2   3   4   5   6   7   8   9   A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z   

This is a individually operated, non profit site. If this site is good enough to show, please introduce this site to others.
Since 2010   ::   HOME   ::   Privacy Policy + Contact