A2SI Datasheet PDF - Zentrum Mikroelektronik Dresden

www.Datasheet-PDF.com

A2SI
Zentrum Mikroelektronik Dresden

Part Number A2SI
Description Release Notes IC Revision C
Page 4 Pages


A2SI datasheet pdf
Download PDF
A2SI pdf
View PDF for Mobile

No Preview Available !

www.DataSheet4U.com
A²SI
Release Notes, IC Revision C
Technical Upgrades in A²SI Revision C
Effected part of the A²SI Description of modification
UART
Telegram Checker
UART
Master Mode
Main State Machine
Slave Mode
Communication Watchdog
Oscillator
The telegram reception under worst case capacitive and worst
case inductive network conditions was improved in response to
suggestions of the technical committee of the AS-International
Association.
The digital MAN-code communication channel does now support
a more cost effective two-wire data transfer between the A²SI
and the master control logic. It is not necessary to rely on the
additional ‘Receive_Strobe’ signal, which is supplied at the pa-
rameter port P2 in Master Mode to verify the correctness of the
MAN output signal at the LED port.
The MAN signal is now distinctively disturbed if an erroneous
telegram was detected at the AS-i input. This allows to spare at
least one opto coupler in between the A²SI and the master con-
trol.
If running, the communication watchdog will now become turned
off as soon as the volatile slave address register is changed to
zero (0x0). This occurs after the reception of a Delete_Address
call or at a reset of the A²SI.
In all previous revisions, a running communication watchdog
could only be turned off by a reset of the A²SI (reception of Re-
set_Slave call or external reset).
In case the watchdog was running and a master did not submit a
Reset_Slave call prior to an address assignment, the write ac-
cess to the non-volatile E²PROM memory could have been inter-
rupted. Because a data corruption is likely in such an event, the
A²SI resumed to the fail save state of slave address zero (0x0)
and did not respond to the newly assigned address until the ad-
dress assignment call was repeated.
The loop gain of the oscillator was increased to support a
broader variety of 8MHz crystals.
Effected part of the A²SI Description of modification
Infrared input channel
Slave Mode
It appeared the infrared input channel (IRD) was sensitive against
coupled noise in some application circuits. In order to make the
photo current input more robust for a broad variety of designs, the
analog receiver circuit had been changed. This resulted in a
much better performance in terms of noise sensitivity but required
a slightly lower signal sensitivity as well. See the updated Data
Sheet for more information.
Release Notes, A²SI Revision C, August 28, 2002 ZMD AG
1/4



No Preview Available !

A²SI
Release Notes, IC Revision C
The replacement of A²SI Revision B with Revision C neither has any impact to required external
components nor requires a change of the external circuitry. The CAP-Pin of an IC of Revision C
shall be connected to a series of one capacitor and one resistor, in the same manner like on Re-
vision B. Suggested values are C=4.7nF, R=430…680 Ohms. See the Data Sheet and the Appli-
cation Notes for more detailed information.
Package Marking
TOP VIEW
BOTTOM
VIEW
A2SI ZMD
C-XXXXYZZ
+
LLLLLL
PIN 1
Figure 1: Package Marking
PIN 1
Top Marking:
A²SI Product name
ZMD
C-
XXXX
Y
ZZ
Manufacturer
Revision code marking of A²SI Revision C
Date code (year and week)
Assembly location
Traceability
Bottom Marking:
LLLLLL
ZMD Lot Number
The yellow dot indicating pre-programmed Master function is printed at the pin 1 marking .
Note: IC Revision A did not have a revision code marking. ICs without a Revision Code are equivalent to
Revision A. Revision B shows “B-“ .
Release Notes, A²SI Revision C, August 28, 2002 ZMD AG
2/4



No Preview Available !

A²SI
Release Notes, IC Revision C
Ordering Information
Ordering
Code
Description
Operating Tempera- Package Type
ture Range
Device
Marking
Shipping Form
A2SI-ST Standard version
of A²SI
-25°C to 85°C
28-pin SSOP
A²SI Tubes
(47 parts/tube)
A2SI-SR Standard version
of A²SI
-25°C to 85°C
28-pin SSOP
A²SI Tape-and-Reel
(1500 parts/reel)
A2SI-MT Pre-programmed
master function
-25°C to 85°C
28-pin SSOP
A²SI
Tubes
+ yellow dot (47 parts/tube)
A2SI-MR Pre-programmed
master function
-25°C to 85°C
28-pin SSOP
A²SI Tape-and-Reel
+ yellow dot (1500 parts/reel)
Sales Contacts
Sales Office Dresden
Zentrum Mikroelektronik Dresden AG
Grenzstraße 28
D-01109 Dresden
Germany
Phone +49-351-8822-310
Fax +49-351-8822-337
sales@zmd.de
Engineering Support
Design Office Dresden
Zentrum Mikroelektronik Dresden AG
Bertolt-Brecht-Allee 22
D-01309 Dresden
Germany
Phone +49-351-31530-86
Fax +49-351-31530-11
asi@zmd.de
Sales Office Long Island
ZMD America Inc.
201 Old Country Road
Melville, NY 11747
USA
Phone +1-631-549-2666
Fax +1-631-549-2882
info@zmda.com
Release Notes, A²SI Revision C, August 28, 2002 ZMD AG
3/4



No Preview Available !

A²SI
Release Notes, IC Revision C
Trademark:
A²SI™ is a trademark of AMI Semiconductor, Inc.
Life Support Policy
ZMD products are not designed, intended, or authorised for use as components in systems intended for surgical implant into the body,
or other applications intended to support or sustain life, or for any other application in which the failure of the ZMD product could
create a situation where personal injury or death may occur.
Components used in life-support devices or systems must be expressly authorised by ZMD for such purpose.
Limited Warranty
The information in this document has been carefully checked and is believed to be reliable. However Zentrum Mikroelektronik Dres-
den (ZMD) makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or
damage of whatever nature resulting from the use of, or reliance upon it. The information in this document describes the type of com-
ponent and shall not be considered as assured characteristics.
ZMD does not guarantee that the use of any information contained herein will not infringe the patent, trademark, copyright, mask work
right or other rights of third parties, and no patent or licence is implied hereby. This document does not in any way extent ZMDs war-
ranty on any product beyond that set forth in its standard terms and conditions of sale.
ZMD reserves terms of delivery and reserves the right to make changes in the products or specifications, or both, presented in this
publication at any time and without notice.
© 2002 Zentrum Mikroelektronik Dresden AG. All rights reserved.
Release Notes, A²SI Revision C, August 28, 2002 ZMD AG
4/4



A2SI datasheet pdf
Download PDF
A2SI pdf
View PDF for Mobile


Related : Start with A2S Part Numbers by
A2S56D20CTP (A2S56D20CTP - A2S56D40CTP) 256Mb DDR SDRAM A2S56D20CTP
Powerchip Semiconductor
A2S56D20CTP pdf
A2S56D30CTP (A2S56D20CTP - A2S56D40CTP) 256Mb DDR SDRAM A2S56D30CTP
Powerchip Semiconductor
A2S56D30CTP pdf
A2S56D40CTP (A2S56D20CTP - A2S56D40CTP) 256Mb DDR SDRAM A2S56D40CTP
Powerchip Semiconductor
A2S56D40CTP pdf
A2S813 Diode A2S813
American Microsemiconductor
A2S813 pdf
A2SHB N-Channel Enhancement mode Field Effect Transistor A2SHB
SLS SEMICONDUCTOR
A2SHB pdf
A2SI Release Notes IC Revision C A2SI
Zentrum Mikroelektronik Dresden
A2SI pdf
A2SI-E Advanced AS-Interface IC A2SI-E
Zentrum Mikroelektronik Dresden
A2SI-E pdf
A2SI-L Low End Device AS-Interface IC A2SI-L
Zentrum Mikroelektronik Dresden
A2SI-L pdf

Index :   0   1   2   3   4   5   6   7   8   9   A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z   

This is a individually operated, non profit site. If this site is good enough to show, please introduce this site to others.
Since 2010   ::   HOME   ::   Contact